When I select any Spot from Cluster or BandMap the equipment goes to the frecquency but allways FIL1 and RTTY mode, instead not is the case.
Any advice that what config I need to change?
Thanks
HI! What Cqrlog version? What rig? What hamlib version?
All them counts. Do you have NewQSO/Preferences/modes a view llike this?
By defaut Cqrlog (2.5.2 and older) knows only modes cw,ssb and rtty. With latest (from source) you can select "data mode" and corresponding rig CAT command to send to rig. In picture if you select mode FT8 (or get it from spot) rig will go to frequency and set mode PKTUSB. It can be set also reverese (having rig PKTUSB will set always FT8 to log), but it is not recommended because it can cause some problems if you work also other modes using rig's PTKUSB.
If your rig is icom (maybe also other brands) setting bandwidth to -1 keeps filter width unchanged. If you have very latest Hamlib (2024-10-xx) it can also select IC7300 filter 1,2,3 by setting bandwith to corresponding 1,2,3 then just filter is selected but it's width is not changed.
I solved the problem about Mode, was the frequency limits.
The problem with Filter is present
The version that I use is 2.5.2 (001), equipment IC-7300 I tried to put -1 on BandWidth but dosen't work
What is the last version of ClubLog? I saw 2.5.2 is the actual I don't found any upgrade
HI!
What Cqrlog version?
What rig?
What hamlib version?
All them counts.
Do you have NewQSO/Preferences/modes a view llike this?
By defaut Cqrlog (2.5.2 and older) knows only modes cw,ssb and rtty. With latest (from source) you can select "data mode" and corresponding rig CAT command to send to rig. In picture if you select mode FT8 (or get it from spot) rig will go to frequency and set mode PKTUSB.
It can be set also reverese (having rig PKTUSB will set always FT8 to log), but it is not recommended because it can cause some problems if you work also other modes using rig's PTKUSB.
If your rig is icom (maybe also other brands) setting bandwidth to -1 keeps filter width unchanged.
If you have very latest Hamlib (2024-10-xx) it can also select IC7300 filter 1,2,3 by setting bandwith to corresponding 1,2,3 then just filter is selected but it's width is not changed.
--
Saku
OH1KH
Dear Saku,
I solved the problem about Mode, was the frequency limits.
The problem with Filter is present
The version that I use is 2.5.2 (001), equipment IC-7300 I tried to put -1 on BandWidth but dosen't work
What is the last version of ClubLog? I saw 2.5.2 is the actual I don't found any upgrade
Thanks
Toni Ea2au
Dear, just now with Alpha_(132)_Gtk2 and seams that all is working well
Thanks
Toni Ea2au