Hi,
when I try to change the profile (new QSO-Window) and switch to remote mode (Ctrl-J), then the profile is reset to the value selected in the preferences.
This behavior is different to local mode, where I can change profile for each new QSQ. I think this is not inteded.
Different profiles are needed in remote mode for example, when different profile parameters apply to different bands.
Also the WSJTX CQ Monitor window opens very tiny, so it has to resized on each switch to remote mode
cqrlog used is release 2.5.1 (001)
73 OE5JWL
Hi!
You have very old version.
Choose remote first, then you can set profile for each qso when remote stays on.
Also minumun size is fixed later on. You could try to set Cq monitor position and size, then check "Map" ad do size/position again, then remove "Map" checkbox and check that CQ monitor is still at same position and size you set it.
Then check "Map" and see that it also has same settings that you made.
After that close remote (Ctrl+J) and Cqrlog.
On next time when opened and remote selected windows should be in place and size.
But most of all, update your version. https://github.com/OH1KH/cqrlog/tree/loc_testing/compiled
There are so many bugs in 2.5.1
--
Saku
OH1KH
ok, I'll try that.
Concerning the newer github version, it is marked to be ALPHA. So is it recommended for 'productive' use?
Johann OE5JWL
Hi Johann!
It is the name I used to call it. I have not invented any better.
It is, and seems will be, different than official Cqrlog. I have no longer sent pull requests to Petr as my version is so far away from his current official source that it would need a very big work to fit them together.
It is , just that I tell in page, the version that I myself use for daily logging. Free to use also for others.
--
Saku
OH1KH