I just installed CQRlog, and got my log imported. I have run into a few problems. First, rig control will not work with my FT-897D. I have it set up at 38400, 8N2. No handshake. It works fine under Grig. device is /dev/ttyUSB0. Also, every now and then I get an "access violation". It says "press OK to ignore and risk data corruption, or cancel to quit program", or something to that effect. I can close CQRlog, open Grig, and the rig control is fine. Any ideas on these problems?
Thanks es 73's,
Jeff
K4LMP
More info:
In inicializerig
Model:123
Port:/dev/ttyUSB0
Baudrate:38400
Databits:8
StopBits:2
Handshake:None
Parity:None
DTR:OFF
RTS:OFF
Poll:50
rig:rig_init called
ft897:ft897_init called
in tRig.Close
rig:rig_close called
select count(*) from cqrlog001.cqrlog_config
Saving ini file to database
www.k4lmp.org
Try Handshake: Hardware.
Tom K8WDX
Tom K8WDX
Tried that, it won't even read the frequency of the radio. Nothing works, but it works fine under Grig. I don't understand it.
www.k4lmp.org
Have you tried to lower baudrate; eg. Baudrate:9600 ?
Cheers,
Vlada, yt1bx
Yes, I tried 9600. Still nothing.
www.k4lmp.org