CQRLOG - open discusion

TRX Control - TS450S very very long response time when change the band by TRX control

Submitted by dl4alb on

Hi,

after a few tries at last I get my TS450S running with TRX control, but if I try to change the band by click the band buttons in TRX control window it takes about 5 to 10 seconds (and sometimes nothing happens) till the transceiver changes the band.

Changes on the transceiver are updated in CQRLOG as fast as expected.

Any hints?

 

Another problem (or not?), when I start CQRLOG at command line I get this running output:

Forums: 

Problem with TRX Control on my TS-940

Submitted by k4ska on

Hello all - I have a TS-940 and cannot get the TRX to see my radio.  I am using an FTDI USB to RS232 device which worked fine under Windows so I know the device is good.
I am not sure what I put into the Device block in the TRX setup under Preferences.  I was going to use /dev/ttyUSBX (where X would be my USB port) but I am not sure which one it is.  
Here is the output from my "lsusb" command:  BTW I  am using Ubuntu 12.04(LTS)

Forums: 

TS-480 suddenly lost rig control

Submitted by aa2up on

I have lost rig control on my Kenwood TS-480-SAT. It was working fine after the upgrade to version 1.5.2--until yesterday. I am using Ubuntu 12.04, 64-bit.

My rig control still works fine with Fldigi, so I know it is not a problem with my serial port.

I have been using the same Cqrlog TRX Control settings for many months with no problems. But suddenly rig control is gone. I tried some other settings, but nothing works.

Please help!

Rich, TI7/AA2UP

This is what I get when I start Cqrlog from terminal:

Forums: 

tq8 file not found cant upload to lotw

Submitted by n1uvi on

when exporting to LOTW
adif export and signing completes with no errors
but when atempting to upload to lotw "Unable to open file"
the dated tq8 file is not being created or if it is
it is not where it is expected to be
I only noticed this problem after upgrading to 1.5.2
has anyone experienced this problem???
 
 
 

Forums: 

KX3 + Ubuntu 12.04

Submitted by NG0R on

Is any one using an Elecraft KX3+CQRLOG? 
I am trying to get my KX3+Elecraft USB cable working with CQRLog without much success. I tried using RIG id 221 (K2) and 229 (K3). Right now the Elecraft USB cable is showing up as /dev/ttyUSB2 when I look via "dmesg"Historically I have had a mix of other rigs and interfaces working via both serial and USB without much issue. (Icom, Yeasu, Kenwood, Elecraft)Any ideas or suggestions?73 de NG0R
 

Forums: 

Pages

Subscribe to RSS - CQRLOG - open discusion