CQRLOG - open discusion

remote mode for fldigi

Submitted by MM0AMV on

I use CQRLog v 1.5.1 with fldigi v 3.21.50 under Kubuntu 12.04.
Normally I have "remote mode for fldigi" activated, and all works fine apart from one small problem.
It seems that CQRLog picks up only the END TIME from fldigi and enters it into both the START TIME and END TIME fields, and so both fields have the same time.
Anyone have any thoughts?

Kind regards

Wallace

Forums: 

nova istalacia cqrlog

Submitted by om0xa on

ahoj. Mam 2 ks PC. Stary a novy. Potreboval by som zo stareho PC skopirovat do noveho vsetky subory, tak aby som v cqrlogu pokracoval bez zmeny. Ide o nastavenia, logy atd. Samozrejme v oboch PC su posledne verzie cqrlogu.
Pravdepodobne treba skopirovat adresar ~/.config/cqrlog zo stareho do noveho PC.
Nasiel som este v ~/ aj adresar ~/cqrlog v ktorom su tiez podobne veci, ale tusim , ze tento je este zo starej verzie cqrlogu 0.9.6.
Pls. treba skopirovat este nieco, su moje uvahy spravne.
MNI TNX, Duro OM0XA.

Forums: 

IOTA Selection

Submitted by G3RTU on

Sorry if this has been discussed previously I presently run two versions 0.9.6 (Suse 11.0) and 1.4.1 (Kbuntu 12.04) and appear to
have a problem with the iota window. On both machines I adif import qso's when correcting IOTA's if the window is not highlighted in RED then selecting the pulldown arrow it crashes.
I can enter manually and appears to be correct in the statistics.
Thank you, Keith, g3rtu

Forums: 

QRZ.com password

Submitted by oh1mrr on

Hi

Has anyone very long passwd in qrz.com. Namely I changed mine there consist 11 marks. And then I changed it in cqr log. Now, when I typed new qso, I got response "wrong passwd". Ok, went to test it with Firefox, worked ok there. Now changed pwd. in qrz into 7 marks and did same in cqrlog. Now it works... Has anyone tested same?

Jarmo

Forums: 

TRX control in v1.5.0

Submitted by GD0AMD on

I have just installed CQRLOG v1.5.0, and it is a pretty impressive piece of software, unfortunately though I have one issue, I cannot get it to talk to my tranceiver.

I am running an Icom IC9100 which is connected to the computer directly by a USB cable.

I have been unable to find information for the required settings for v1.5.0, so I may have got my set up wrong,

Forums: 

Pages

Subscribe to RSS - CQRLOG - open discusion