CQRLOG - open discusion

UTC Setting

Submitted by k4msr on

I'm using Ubuntu 11.04 the program is running ok but the time does not work correctly. The offset in the State of Virginia is 5 hours if I use a stting of "0" in the Program -Preferences the local time is correct when I use "5" it seems to go in the wrong direction I have tried entering the number many ways and never coming close to the correct time. It does not seem to do the math correctly. Any ideas !

Forums: 

Multiple instance question

Submitted by K7TKT on

Hi all:

I read that the best way to support multiple calls, such as for an event call sign, was to install multiple instances of CQRLOG. I am having a problem installing the second instance. I am running the installation specifying a new destination directory. When I do this I receive an error:
"Creating target directory..."
"Error while creating target directory!"

I have tried running the installer both normally and under sudo. Same problem. I am running Ubuntu 10.04 and CQRLOG 9.6. Is there a special procedure for installing additional instances of CQRLOG?

Forums: 

cqrlog Ft-2000

Submitted by kc2cwt on

Hello all ,
Looking for some help , As i am new to linux
I am running Ubuntu 10.04 lts Lucid 64 bit .
I have CQRLOG installed and running .
I have hamlib-1.2.12 running .
I go to a cmd line and go to the dir wear hamlib is ,
i start it with rigctl -m 129 -r /dev/ttyUSB0 -s 38400 -C stop_bits=1 -C data_bits=8

and get this
Rig command:
send: f and i get this err

get_freq: error = Protocol error

Rig command:
budrate is set to 38400 on the radio

looking for some help on this ,
Thanks Bob KC2CWT

Forums: 

Yaesu FT-817ND Operating Mode showing as NONE

Submitted by m0dcm on

Hey There,
I've been running CQRLog for a few months now, but have only just noticed when swithing the operating mode from FM to FMN, that it shows up as none in the window. Is there or have I done something wrong? I use FMN a lot on 2m, as there's a lot of operators nearby.

Cheers in advance for any info.

Dave M0DCM
PC - Acer Aspire One AO751h
OS - Ubuntu 9.10
RIG - Yaesu FT-817ND

Forums: 

CQRLOG failing on Fedora 14

Submitted by W4OTN on

I recently upgraded my laptop from Fedora 13 to Fedora 14. I'm now getting an error when I try to start CQRLOG that says "Cannot load library: /home/user/cqrlog/lib/libfbembed.so2.1.1." Since this was an upgrade, and CQRLOG was previously installed, nothing changed on the install of CQRLOG.

I had to rebuild another computer and when I try to install CQRLOG on that computer, also running Fedora 14, I get the following error:

$ ./cqrlog_install.sh

CQRLOG self extracting installer

./files.tar
./install

Forums: 

Pages

Subscribe to RSS - CQRLOG - open discusion