CQRLOG - open discusion

QSO list & NEW QSO list columns; FT817 read status

Submitted by YO9GRD on

Hi!

Is possible to set column width on QSO window and worked before columns in New QSO window to autowidth?
And a "burning" question for me.... Is possible that after connecting the rig to read each band frequencies and assign them to the TRX window control buttons?
I do not keep the same frequency band and is always annoying to setup other common frequencies...

I use FT817ND

73 Bogdan

Forums: 

1) LoTW multiple callsigns 2) Group edit

Submitted by sq6nte on

Hi,

I have just upgraded to 0.9.6, and noticed that when I modify remarks field with the "Group edit" option, all is converted to uppercase. Is this a bug or a feature? In the 0.9.5 it worked without conversion and I liked it.

Another and more important issue is that from some time, but I cannot tell for how long, only LoTW contacts with my regular callsign are imported. I have had some more certificates like /P, /M etc., and now these contacts are not even downloaded from LoTW. It worked well a couple of months ago, but then it stopped. What can I do to get this working again?

Forums: 

UTC Setting

Submitted by k4msr on

I'm using Ubuntu 11.04 the program is running ok but the time does not work correctly. The offset in the State of Virginia is 5 hours if I use a stting of "0" in the Program -Preferences the local time is correct when I use "5" it seems to go in the wrong direction I have tried entering the number many ways and never coming close to the correct time. It does not seem to do the math correctly. Any ideas !

Forums: 

Multiple instance question

Submitted by K7TKT on

Hi all:

I read that the best way to support multiple calls, such as for an event call sign, was to install multiple instances of CQRLOG. I am having a problem installing the second instance. I am running the installation specifying a new destination directory. When I do this I receive an error:
"Creating target directory..."
"Error while creating target directory!"

I have tried running the installer both normally and under sudo. Same problem. I am running Ubuntu 10.04 and CQRLOG 9.6. Is there a special procedure for installing additional instances of CQRLOG?

Forums: 

cqrlog Ft-2000

Submitted by kc2cwt on

Hello all ,
Looking for some help , As i am new to linux
I am running Ubuntu 10.04 lts Lucid 64 bit .
I have CQRLOG installed and running .
I have hamlib-1.2.12 running .
I go to a cmd line and go to the dir wear hamlib is ,
i start it with rigctl -m 129 -r /dev/ttyUSB0 -s 38400 -C stop_bits=1 -C data_bits=8

and get this
Rig command:
send: f and i get this err

get_freq: error = Protocol error

Rig command:
budrate is set to 38400 on the radio

looking for some help on this ,
Thanks Bob KC2CWT

Forums: 

Pages

Subscribe to RSS - CQRLOG - open discusion